It's great for beginners and easy to do.
This is the Beetle Robot you are going to build:
Before starting, I suggest you to read the complete tutorials. This will greatly lower the chances of you making a mistake.
Tools Needed:
- soldering iron
- electronic solder
- diagonal cutter
- Mini glue gun
- 2x - small 1.5 Volts motors
- 2x - small paperclips
- 2x - big paperclips
- 2x - batteries AAA or AA
- 1x - battery holder AAA or AA
- 1x - 2 cm of heat shrink
- 1x - wooden pearl (for the caster)
- 1x - meter of electric wire
- 2x - Sub-mini lever SPDT switches
Here are the serial numbers of the components and tools
Component | Number |
soldering iron | 64-2184 |
electronic solder | 64-006 |
diagonal cutter | 64-2951 |
1.5 Volts motor | 273-223 |
battery holder | 270-398 |
SPDT switch | 275-016 |
Here is all the parts for the construction the beetle robot.
1. Cut the electric wire in pieces of 6 cm each, 13 times.
Strip 1 cm at each end.
2. Regroup all the components.
3. Solder each wire to each components except the two batteries.
4. Take the battery holder and make a connection to the connection.
This will give a third connection.See picture below.
5. Turn the battery holder up side down so the batteries point to the ground. Glue the two switches on the battery holder in a V form
Take the big paperclip and make the caster like the picture below.
You can make a nice looking caster or a normal one
FOR COMPLETE AND CLEAR INFORMATION ABT THE BEETLE BOT PLEASE VISIT THE GOROBOTICS LINK IN THE LINK AREA ON THE TOP RIGHT
No comments:
Post a Comment